Sensors for National Instruments DAQ
English  

Event Marker


$50.00


Overview
The EMN-100 is a hand-held, push button switch. When the button is pressed, the EMN-100 delivers a TTL pulse, which is displayed on the selected channel of the recording software.

Specifications

Input Range

N/A

Output Range

0V to 4.3V

Calibration

N/A

Default scaling Value

N/A



Measurement Instructions
1. Install the IX-ELVIS board into the National Instrument ELVIS platform or the IX-myDAQ board onto the NI myDAQ. If using ELVIS, connect the ELVIS power supply to the ELVIS unit and connect it to the computer via a USB cable. Ensure both of the power switches are in the “on” position. For the myDAQ, connect it to the computer using the USB cable.

2. Connect the MINI DIN7 connector of the EMN-100 to either CH1 or CH2 of either the IX-ELVIS or IX-myDAQ board.

3. Open the recording software, select the channel that the EMN-100 is connected to and ensure the range is set to +/-5V.

4. Press record and push the button to record desired events occurs.

*Note: The signal may be inverted while using the IX-MYDAQ.
  • Model: EMN-100

Be the first to write a review.  Write a Review.



Who's Online

There currently are 3 guests online.